Command Line Reference Guide

Defaults Not enabled.
Command Modes
• CONFIGURATION-STANDARD-ACCESS-LIST
• CONFIGURATION-EXTENDED-ACCESS-LIST
• CONFIGURATION-MAC ACCESS LIST-STANDARD
• CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command History
Version 9.0(1.3) Introduced on the S5000.
remark
Enter a description for an ACL entry.
S5000
Syntax
remark [remark-number] [description]
Parameters
remark-number Enter the remark number. The range is 0 to 4294967290.
NOTE: You can use the same sequence number for the remark
and an ACL rule.
description Enter a description of up to 80 characters.
Defaults Not configured.
Command Modes
• CONFIGURATION-STANDARD-ACCESS-LIST
• CONFIGURATION-EXTENDED-ACCESS-LIST
• CONFIGURATION-MAC ACCESS LIST-STANDARD
• CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The remark command is available in each ACL mode. You can configure up to 4294967290
remarks in a given ACL.
The example below shows the use of the remark command twice within CONFIGURATION-
STANDARD-ACCESS-LIST mode. The same sequence number was used for the remark and for
an associated ACL rule. The remark precedes the rule in the running-config because it is
assumed that the remark is for the rule with the same sequence number, or the group of rules
that follow the remark.
Example
FTOS(config-std-nacl)#remark 10 Deny rest of the traffic
FTOS(config-std-nacl)#remark 5 Permit traffic from XYZ Inc.
FTOS(config-std-nacl)#show config
178