Command Line Reference Guide
8
Access Control Lists (ACL)
Access control lists (ACLs) are supported on the S5000 switch.
FTOS supports the following types of ACL, IP prefix list, and route maps:
• Commands Common to all ACL Types
• Common IP ACL Commands
• Standard IP ACL Commands
• Extended IP ACL Commands
• Common MAC Access List Commands
• Standard MAC ACL Commands
• Extended MAC ACL Commands
• IP Prefix List Commands
• Route Map Commands
• AS-Path Commands
• IP Community List Commands
NOTE: For ACL commands that use the Trace function, refer to the Trace List Commands section in the Security
chapter.
NOTE: For IPv6 ACL commands, refer to IPv6 Access Control Lists (IPv6 ACLs).
Commands Common to all ACL Types
The following commands are available within each ACL mode and do not have mode-specific options. Some commands
in this chapter may use similar names, but require different options to support the different ACL types (for example, the
deny and permit commands).
description
Configure a short text string describing the ACL.
S5000
Syntax
description text
Parameters
text
Enter a text string up to 80 characters long.
177