Command Line Reference Guide
set the management port ip address and mask
interface management port config 1000m
set the management port at 1000m
interface management port config 100m
set the management port at 100m
interface management port config 10m
set the management port at 10m
interface management port config auto-negotiate
set the management port to auto negotiate
interface management port config full-duplex
set the management port to full-duplex
interface management port config half-duplex
set the management port to half-duplex
-(60%)-Use <CR>> to continue, q to stop:
interface management port config no auto-negotiate
set the management port to no auto negotiate. set speed
and duplex to def
ault values of (100m/full-duplex)
no default-gateway
clear the default gateway ip address
no interface management ethernet ip address
clear the management port ip address and mask
reload
reload entire chassis
show boot blc
show the boot loop counter value
show boot selection
display rom bootstrap bootflash partition
show bootflash
summary display of boot flash information
show bootvar
summary display of operating system boot parameters
show default-gateway
display the default gateway ip address
show interface management ethernet
display the management port ip address and mask
-(93%)-Use <CR>to continue, q to stop:
show interface management port config
show the management port boot characteristics
syntax help
show syntax information
ignore enable password
Ignore the enabled password.
S5000
Syntax
ignore enable password
Command Modes BOOT USER
Command History
Version 9.0(1.3) Introduced on the S5000.
169