Command Line Reference Guide

Boot User Mode

All commands in this chapter are available in Boot User mode on the S5000.

To access this mode, press any key when the following line appears on the console during a system boot:

Hit any key to stop autoboot:

You enter Boot User mode immediately, as indicated by the BOOT_USER# prompt.

NOTE: You cannot use the Tab key to complete commands in this mode.

boot change

Change the boot parameters in the operating system.

S5000

Syntax

boot change {primary | secondary | default}

Command Modes BOOT USER

Parameters

primary Set the S5000 to boot up with the primary boot parameters.

secondary Set the S5000 to boot up with the secondary boot parameters.

default Set the S5000 to boot up with the default boot parameters.

Default The S5000 boots up using the primary boot parameters if they are valid. If the primary

parameters are not valid, the switch boots with the secondary parameters. If the secondary

parameters are not valid, it boots with the default parameters.

Command History

Version 9.0(1.3) Introduced on the S5000.

boot messages disable

Deactivate the NetBSD boot log. By default, the NetBSD log is disabled.

S5000

Syntax

boot messages disable

165