Command Line Reference Guide

show dot1x interface
Display the 802.1X configuration of an interface.
S5000
Syntax
show dot1x interface type slot/port [mac-address mac-address]
Parameters
interface type
slot/port
Enter the interface keyword followed by the interface type and
slot/port or number information. Valid slot numbers are 0-11. The valid
port numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
mac-address (Optional) MAC address of a supplicant.
Defaults none
Command Modes
• EXEC
• EXEC privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
If you enable 802.1X multi-supplicant authentication on a port, additional 802.1X configuration
details (Port Authentication status, Untagged VLAN ID, Authentication PAE state, and Backend
state) are displayed for each supplicant, as shown in the Example below.
Example
(Interface)
FTOS#show dot1x int te 2/32
802.1x information on Te 2/32:
-----------------------------
Dot1x Status: Enable
Port Control: AUTO
Port Auth Status: UNAUTHORIZED
Re-Authentication: Disable
Untagged VLAN id: None
Guest VLAN: Enable
Guest VLAN id: 10
Auth-Fail VLAN: Enable
Auth-Fail VLAN id: 11
Auth-Fail Max-Attempts: 3
Tx Period: 30 seconds
Quiet Period: 60 seconds
ReAuth Max: 2
Supplicant Timeout: 30 seconds
Server Timeout: 30 seconds
Re-Auth Interval: 3600 seconds
Max-EAP-Req: 2
Auth Type: SINGLE_HOST
163