Command Line Reference Guide
• Enable MAC authentication bypass on the port (the dot1x mac-auth-bypass
command).
In MAB-only authentication mode, a port authenticates using the host MAC address even
though 802.1xauthentication is enabled. If the MAB-only authentication fails, the host is placed
in the guest VLAN (if configured).
To disable MAB-only authentication on a port, enter the no dot1x auth-type mab-
only
command.
Related
Commands
dot1x mac-auth-bypass
dot1x authentication (Configuration)
Enable dot1x globally. Enable dot1x both globally and at the interface level.
S5000
Syntax
dot1x authentication
To disable dot1x on a globally, use the no dot1x authentication command.
Defaults Disabled
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
dot1x authentication (Interface)
dot1x authentication (Interface)
Enable dot1x on an interface. Enable dot1x both globally and at the interface level.
S5000
Syntax
dot1x authentication
To disable dot1x on an interface, use the no dot1x authentication command.
Defaults Disabled
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
154