Command Line Reference Guide

mep cross-check
Enable cross-checking for a MEP.
S5000
Syntax
mep cross-check mep-id
Parameters
mep-id Enter the MEP ID. The range is 1 to 8191.
Defaults none
Command Modes ECFM DOMAIN
Command History
Version 9.0(1.3) Introduced on the S5000.
mep cross-check enable
Enable cross-checking.
S5000
Syntax
mep cross-check enable {port | vlan-id}
Parameters
port Down service with no VLAN association.
vlan-id Enter the VLAN to apply the cross-check.
Defaults none
Command Modes ECFM DOMAIN
Command History
Version 9.0(1.3) Introduced on the S5000.
mep cross-check start-delay
Configure the amount of time the system waits for a remote MEP to come up before the cross-check operation is
started.
S5000
Syntax
mep cross-check start-delay number
141