Command Line Reference Guide

For a Management interface, enter the keyword
managementethernet followed by slot/port numbers.
The port is 0.
For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
For a VLAN interface, enter the keyword vlan followed by a
VLAN id number from 1 to 4094.
Defaults
Timeout = 5 seconds
Probe count = 3
30 hops max
40 byte packet size
UDP port = 33434
Command Modes
EXEC
EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When you enter the traceroute command without specifying an IP address (Extended
Traceroute), you are prompted for a target and source IP address, timeout (in seconds) (default
is 5), a probe count (default is 3), minimum TTL (default is 1), maximum TTL (default is 30), and
port number (default is 33434). To keep the default setting for those parameters, press the
ENTER key.
For the source IP address option, you may enter IPv6 global addresses only (link-local
addresses are not supported).
For IPv6, you are prompted for a minimum hop count (default is 1) and a maximum hop count
(default is 64).
Example (name )
FTOS#traceroute www.dell.com
Translating "www.dell.com"...domain server (10.11.0.1) [OK]
Type Ctrl-C to abort.
-----------------------------------------------------------
Tracing the route to www.dell.com (10.11.84.18),
30 hops max, 40 byte packets
-----------------------------------------------------------
TTL Hostname Probe1 Probe2 Probe3
1 10.11.199.190 001.000 ms 001.000 ms 002.000 ms
2 gwegress-sjc-02.dell.com (10.11.30.126) 005.000 ms 001.000
ms 001.000 ms
3 fw-sjc-01.dell.com (10.11.127.254) 000.000 ms 000.000 ms
000.000 ms
4 www.dell.com (10.11.84.18) 000.000 ms 000.000 ms 000.000 ms
FTOS#
Example (IPv4)
FTOS#traceroute 10.1.1.1
Type Ctrl-C to abort.
134