Command Line Reference Guide
vrrp-group
Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface.
S5000
Syntax
vrrp-group vrrp-id
Parameters
vrrp-id
Enter a number as the group ID. The range is 1 to 255.
Defaults Not configured.
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The VRRP group only becomes active and sends VRRP packets when a virtual IP address is
configured. When you delete the virtual address, the VRRP group stops sending VRRP packets.
Related
Command
virtual-address – assigns up to 12 virtual IP addresses per VRRP group.
IPv6 VRRP Commands
The following are IPv6 VRRP commands.
The following commands apply to IPv4 and IPv6:
• advertise-interval
• description
• disable
• hold-time
• preempt
• priority
• show config
• track
• virtual-address
1313