Command Line Reference Guide
show vrrp
View the VRRP groups that are active. If no VRRP groups are active, the FTOS returns No Active VRRP group.
S5000
Syntax
show vrrp [vrrp-id] [interface-type slot/port] [brief] | [ipv6]
Parameters
vrrp-id
(OPTIONAL) Enter the Virtual Router Identifier for the VRRP group to
view only that group. The range is 1 to 255.
interface-type
slot/port
(OPTIONAL) Enter the interface type followed by slot/port or number
information. Valid slot numbers are 0-11. The valid port numbers for
each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed by a
VLAN id number from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of information
on the VRRP groups on the S5000.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The following describes output from the show vrrp brief command shown in the
Example below.
Item Description
Interface Lists the interface type, slot and port on which the VRRP group is
configured.
Grp Displays the VRRP group ID.
Pri Displays the priority value assigned to the interface. If the track
command is configured to track that interface and the interface is
disabled, the cost is subtracted from the priority value assigned to the
interface.
Pre States whether preempt is enabled on the interface.
1307