Command Line Reference Guide

priority
Specify a VRRP priority value for the VRRP group. This value is used by the VRRP protocol during the MASTER election
process.
S5000
Syntax
priority priority
To return to the default value, use the no priority command.
Parameters
priority
Enter a number as the priority. Enter 255 only if the router’s virtual
address is the same as the interface’s primary IP address (that is, the
router is the OWNER). The range is 1 to 255. The default is 100.
Defaults 100
Command Modes VRRP
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s virtual
address with same IP address as the interface’s primary IP address and change the priority of
the VRRP group to 255.
If you set the priority command to 255 and the virtual-address is not equal to the
interface’s primary IP address, an error message appears.
show config
View the non-default VRRP configuration.
S5000
Syntax
show config [verbose]
Parameters
verbose (OPTIONAL) Enter the keyword verbose to view all VRRP group
configuration information, including defaults.
Command Modes VRRP
Command History
Version 9.0(1.3) Introduced on the S5000.
Example
FTOS(conf-if-vrid-4)#show con
vrrp-group 4
virtual-address 119.192.182.124
!
1306