Command Line Reference Guide

debug vrrp
Allows you to enable debugging of VRRP.
S5000
Syntax
debug vrrp [vrrp-id] | [interface-type slot/port] | [interface]
| {all | packets | state | timer}
To disable debugging, use the no debug vrrp [interface-type slot/port] |
[interface][vrrp-id] {all | packets | state | timer} command.
Parameters
interface-type
slot/port
Enter the interface type followed by slot/port or number information to
turn on debugging for specific interfaces. Valid slot numbers are 0-11.
The valid port numbers for each interface type are listed below.
For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
For a VLAN interface, enter the keyword vlan followed by a
VLAN id number from 1 to 4094.
interface Enter the interface keyword to enable debugging of all groups on
all interfaces.
vrrp-id
(OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
all Enter the keyword all to enable debugging of all VRRP groups.
bfd Enter the keyword bfd to enable debugging of all VFFP BFD
interactions.
packets Enter the keyword packets to enable debugging of VRRP control
packets.
state Enter the keyword state to enable debugging of VRRP state
changes.
timer Enter the keyword timer to enable debugging of the VRRP timer.
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
If no options are specified, debug is active on all interfaces and all VRRP groups.
1303