Command Line Reference Guide

Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Use the peer-down-vlan parameter to configure the VLAN from where the VLT peer
forwards packets received over the VLTi from an adjacent VLT peer that is down. When a VLT
peer with bare metal provisioning (BMP) is booting up, it sends untagged DHCP discover
packets to its peer over the VLTi. Use this configuration to ensure that the DHCP discover
packets are forwarded to the VLAN on the DHCP server.
primary-priority
Assign the priority for master election among VLT peers.
S5000
Syntax
[no] primary-priority
Parameters
value
To configure the primary role on a VLT peer, enter a lower value than
the priority value of the remote peer. The range is 1 to 65535.
Default 32768
Command Modes VLT DOMAIN
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
After you configure the VLT domain on each peer switch on both sides of the interconnect
trunk, by default, the FTOS software elects a primary and secondary VLT peer device. Use the
priority command to reconfigure the primary role of VLT peer switches.
show vlt
Displays status information about VLT domains currently configured on the switch.
S5000
Syntax
show vlt [brief | detail]
Default Not configured.
Command Modes EXEC
Command History
Version 9.0(1.3) Introduced on the S5000.
1292