Command Line Reference Guide
stack-unit stack-group
Configure stacking group specified by ID.
S5000
Syntax
[no] stack-unit unit-number stack-group stack-group-number
Parameters
unit-number
Enter the stack unit number. The range is 0 to 11..
stack-group-id
Enter the stack group number. The range is 0 to 15.
[no] Use no stack-unit unit-id stack-group stack-id
to remove the current stack group configuration.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
WARNING: The following message displays to confirm the command: All non-
default configurations on the related member ports ports
(<ports listed here>) will be removed. Do you want to
continue (y/n)? If you enter “y”, all non-default configurations on any member
ports of the current stack group is removed when the unit is rebooted.
vlan-stack access
Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
S5000
Syntax
vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults Not configured.
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Prior to enabling this command, you must enter the switchport command to place the
interface in Layer 2 mode.
To remove the access port designation, the port must be removed (using the no member
interface command) from all stackable VLAN enabled VLANs.
1284