Command Line Reference Guide

Related
Commands
dei honor
show interfaces dei-mark
Display the dei mark configuration.
S5000
Syntax
show interfaces dei-mark [interfacetype slot/port | stack—unit
unit-number port-set number]
Parameters
interface-type
slot/port
Enter the interface keyword followed by the interface type and
slot/port or number information. Valid slot numbers are 0-11. The valid
port numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number from 1 to 128.
stack-unit unit-
number port-set
number
Enter the keyword stack-unit followed by the unit number. The
range is 0 to 11. Then enter the keyword
port-set followed by the
port-pipe number.
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Example
FTOS#show interfaces dei-mark
Default CFI/DEI Marking: 0
Interface Drop precedence CFI/DEI
------------------------------------------------
Te 0/1 Green 0
Te 0/1 Yellow 1
Te 8/9 Yellow 0
Te 8/40 Yellow 0
Related
Commands
dei mark
1283