Command Line Reference Guide

Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You must enable the stackable VLAN (using the vlan-stack compatible command) on
the VLAN prior to adding a member to the VLAN.
Related
Commands
vlan-stack compatible – enables stackable VLAN on a VLAN.
show interfaces dei-honor
Display the dei honor configuration.
S5000
Syntax
show interfaces dei-honor [interface-type slot/port | stack—
unit unit-number port-set number]
Parameters
interface-type
slot/port
Enter the interface keyword followed by the interface type and
slot/port or number information. Valid slot numbers are 0-11. The valid
port numbers for each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
stack-unit unit-
number port-set
number
Enter the keywords stack-unit followed by the unit number. The
range is 0 to 11. Then enter the keywords port-set followed by the
port-pipe number.
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Example
FTOS#show interfaces dei-honor
Default Drop precedence: Green
Interface CFI/DEI Drop precedence
---------------------------------------------
Te 0/1 0 Green
Te 0/1 1 Yellow
Te 8/9 1 Red
Te 8/40 0 Yellow
1282