Command Line Reference Guide
• uplink-state-group – creates an uplink-state group and enables the tracking of
upstream links.
downstream auto-recover
Enable auto-recovery so that UFD-disabled downstream ports in an uplink-state group automatically come up when a
disabled upstream port in the group comes back up.
S5000
Syntax
downstream auto-recover
To disable auto-recovery on downstream links, use the no downstream auto-recover
command.
Defaults The auto-recovery of UFD-disabled downstream ports is enabled.
Command Modes UPLINK-STATE-GROUP
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
• downstream – assigns a port or port-channel to the uplink-state group as a
downstream interface.
• uplink-state-group – creates an uplink-state group and enables the tracking of
upstream links.
downstream disable links
Configure the number of downstream links in the uplink-state group that will be disabled if one upstream link in an
uplink-state group goes down.
S5000
Syntax
downstream disable links {number |all}
To revert to the default setting, use the no downstream disable links command.
Parameters
number
Enter the number of downstream links to be brought down by UFD.
The range is 1 to 1024.
all Brings down all downstream links in the group.
Defaults No downstream links are disabled when an upstream link in an uplink-state group goes down.
Command Modes UPLINK-STATE-GROUP
1272