Command Line Reference Guide

ntp broadcast client
Set up the interface to receive NTP broadcasts from an NTP server.
S5000
Syntax
ntp broadcast client
To disable broadcast, use the no ntp broadcast client command.
Defaults Disabled.
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
ntp disable
Prevent an interface from receiving NTP packets.
S5000
Syntax
ntp disable
To re-enable NTP on an interface, use the no ntp disable command.
Defaults Disabled (that is, if you configure an NTP host, all interfaces receive NTP packets)
Command Modes INTERFACE
Command History
Version 9.0(1.3) Introduced on the S5000.
ntp multicast client
Configure the switch to receive NTP information from the network via multicast.
S5000
Syntax
ntp multicast client [multicast-address]
To disable multicast reception, use the no ntp multicast client [multicast-
address] command.
Parameters
multicast-
address
(OPTIONAL) Enter a multicast address. Enter either an IPv4 address in
dotted decimal format or an IPv6 address in X:X:X:X::X format. If you
do not enter a multicast address, the address:
1261