Command Line Reference Guide
Defaults none
Command Modes INTERFACE (conf-if-
interface-slot/port
)
Command History
Version 9.0(1.3) Introduced on the S5000.
storm-control multicast (Configuration)
Configure the packets per second (pps) of multicast traffic allowed in to S5000 networks.
S5000
Syntax
storm-control multicast packets_per_second in
To disable storm-control for multicast traffic into the network, use the no storm-control
multicast
packets_per_second in command.
Parameters
packets_per_sec
ond
in
Enter the packets per second of multicast traffic allowed into the
network. The range is 0 to 33554431.
Defaults none
Command Modes CONFIGURATION (conf)
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Broadcast traffic (all 0xFs) should be counted against the broadcast storm control meter, not
against the multicast storm control meter. It is possible, however, that some multicast control
traffic may get dropped when storm control thresholds are exceeded.
storm-control multicast (Interface)
Configure the percentage of multicast traffic allowed on an S5000 interface (ingress only) network only.
S5000
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control
multicast
packets_per_second in command.
Parameters
packets_per_sec
ond
in
Enter the packets per second of broadcast traffic allowed into the
network. The range is 0 to 33554431.
1249