Command Line Reference Guide
Example
FTOS#show storm-control unknown-unicast tengigabitethernet 3/0
Unknown-unicast storm control configuration
Interface Direction Packets/Second
---------------------------------------
Te 3/0 Ingress 1000
FTOS#
storm-control broadcast (Configuration)
Configure the percentage of broadcast traffic allowed in or out of the network.
S5000
Syntax
storm-control broadcast [packets_per_second in]
To disable broadcast rate-limiting, use the no storm-control broadcast
packets_per_second in] command.
Parameters
packets_per_sec
ond
in
Enter the packets per second of broadcast traffic allowed into the
network. The range is 0 to 33554431.
Defaults none
Command Modes CONFIGURATION (conf)
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2 broadcast traffic is
treated as unknown-unicast traffic.
storm-control broadcast (Interface)
Configure the percentage of broadcast traffic allowed on an interface (ingress only).
S5000
Syntax
storm-control broadcast [packets_per_second in]
To disable broadcast storm control on the interface, use the no storm-control
broadcast [
packets_per_second in] command.
Parameters
packets_per_sec
ond
in
Enter the packets per second of broadcast traffic allowed into the
network. The range is 0 to 33554431.
1248