Command Line Reference Guide

upgrade system (stack unit)
Upgrade the FTOS image on one or all stack units in an S5000 stack from the master switch.
S5000
Syntax
upgrade system {flash://file-path | ftp://file-path | scp://
file-path | tftp://file-path | usbflash://file-path} | stack-
unit {stack-unit—id | all}{A: | B:}}
Parameters
boot Enter the keyword system to change the FTOS image.
flash: After the keyword flash:, enter the location of the source file in the
internal flash in the format: //file-pathname or press Enter to
launch a prompt sequence.
ftp: After the keyword ftp:, enter the location of the source file in the
format:
//userid:password@host-ipaddress/file—
pathname or press Enter to launch a prompt sequence.
scp: After the keyword scp:, enter the location of the source file in the
format: //userid:password@host-ip-address/file-
pathname or press Enter to launch a prompt sequence.
tftp: After the keyword tftp:, enter the location of the source file in the
format: //host-ipaddress/file-pathname or press Enter
to launch a prompt sequence.
usbflash: After the keyword usbflash:, enter the location of the source file
in the external flash in the format: //file-path or press Enter to
launch a prompt sequence.
file-path
Enter the path and filename to be used to upgrade the FTOS image.
stack-unit {
stack-
unit-id
| all}
Enter the keyword stack-unit: followed by the stack unit ID of a
member unit or
all to upgrade the boot image on all stack member
units. Valid stack-unit ID numbers are 0 to 11.
A:
|
B:
Enter the FTOS partition to be upgraded with the new image.
Defaults None
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You must reload FTOS after executing this command. Use the upgrade system stack-
unit command to copy FTOS from the management unit to one or more stack members.
Example
FTOS#upgrade system ?
flash: Copy from flash file system (flash://filepath)
ftp: Copy from remote file system, IPv4 or IPv6, (ftp://
userid:password@hostip/filepath)
scp: Copy from remote file system, IPv4 or IPv6, (scp://
userid:password@hostip/filepath)
stack-unit: Sync image to the stack-unit
1242