Command Line Reference Guide

• show system – displays the status of all stack members or a specific member.
stack-unit renumber
Change the stack-unit number of any stack unit or a stand-alone S5000.
S5000
Syntax
stack-unit unit-number renumber unit-number
Parameters
unit-number
renumber
Enter the stack-unit number followed by the keyword renumber.
The range is 0 to 11. The first instance of this value is the currently
configured unit number of an S5000 switch. The second instance of
this value is the new unit number to be assigned to the switch.
Defaults none
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You can renumber any switch, including the management unit or a stand-alone unit.
You cannot renumber a unit to a number of an active member in the stack.
When executing this command on the master, the stack reloads. When the members are
renumbered, only that specific unit is reset and comes up with the new unit number.
Example
FTOS#stack-unit 5 renumber 6
Renumbering will reset the unit.
Warning: Interface configuration for current unit will be lost!
Proceed to renumber [confirm yes/no]:
Related
Commands
• reload – reboots FTOS.
• reset stack-unit – resets the designated S5000 stack member.
• show system – displays the current status of all stack members or a specific member.
1238