Command Line Reference Guide

Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You must enable spanning tree group 0 prior to using this command.
The following describes the show spanning-tree 0 command shown in the Example
below.
Field Description
Bridge Identifier... Lists the bridge priority and the MAC address for this STP bridge.
Configured
hello...
Displays the settings for hello time, max age, and forward delay.
We are... States whether this bridge is the root bridge for the STG.
Current root... Lists the bridge priority and MAC address for the root bridge.
Topology flag... States whether the topology flag and the detected flag were set.
Number of... Displays the number of topology changes, the time of the last
topology change, and on what interface the topology change
occurred.
Timers Lists the values for the following bridge timers: hold time, topology
change, hello time, max age, and forward delay.
Times List the number of seconds since the last:
• hello time
• topology change
• notification
• aging
Port 1... Displays the Interface type slot/port information and the status of the
interface (Disabled or Enabled).
Port path... Displays the path cost, priority, and identifier for the interface.
Designated root... Displays the priority and MAC address of the root bridge of the STG
that the interface belongs.
Designated port... Displays the designated port ID.
Example
FTOS#show spann 0
Executing IEEE compatible Spanning Tree Protocol
Bridge Identifier has priority 32768, Address 0001.e800.0a56
Configured hello time 2, max age 20, forward delay 15
We are the root of the spanning tree
Current root has priority 32768 address 0001.e800.0a56
Topology change flag set, detected flag set
Number of topology changes 1 last change occurred 0:00:05 ago
from TenGigabitEthernet 1/3
Timers:hold 1, topology change 35
hello 2, max age 20, forward_delay 15
Times:hello 1, topology change 1, notification 0, aging 2
Port 26 (TenGigabitEthernet 1/1) is Forwarding
1227