Command Line Reference Guide

Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
forward-delay – changes the wait time before STP transitions to the Forwarding state.
hello-time – changes the time interval between BPDUs.
protocol spanning-tree
Enter SPANNING TREE mode to enable and configure the spanning tree group.
S5000
Syntax
protocol spanning-tree stp-id
To disable the Spanning Tree group, use the no protocol spanning-tree stp-id
command.
Parameters
stp-id Enter zero (0). FTOS supports one spanning tree group, group 0.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
STP is not enabled when you enter SPANNING TREE mode. To enable STP globally on the
switch, use the no disable command from SPANNING TREE mode.
Example
FTOS(conf)#protocol spanning-tree 0
FTOS(config-stp)#
Related
Commands
disable – disables spanning tree group 0. To enable spanning tree group 0, use the no
disable command.
show config
Display the current configuration for the mode. Only non-default values are displayed.
S5000
Syntax
show config
Command Modes SPANNING TREE
1225