Command Line Reference Guide
snmp-server packetsize
Set the largest SNMP packet size permitted. Wen the SNMP server is receiving a request or generating a reply, use the
snmp-server packetsize global configuration command.
S5000
Syntax
snmp-server packetsize byte-count
Parameters
byte-count
Enter one of the following values 8, 16, 24 or 32. Packet sizes are 8000
bytes, 16000 bytes, 32000 bytes, and 64000 bytes.
Defaults 8
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
snmp-server trap-source
Configure a specific interface as the source for SNMP traffic.
S5000
Syntax
snmp-server trap-source interface-type slot/port
To disable sending traps out a specific interface, use the no snmp trap-source
command.
Parameters
interface-type
slot/port
Enter the interface type and slot/port or number information. Valid slot
numbers are 0-11. The valid port numbers for each interface type are
listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a VLAN interface, enter the keyword vlan followed by a
VLAN id number from 1 to 4094.
Defaults The IP address assigned to the management interface is the default.
Command Modes CONFIGURATION
1202