Command Line Reference Guide

Example
FTOS#conf
FTOS(conf)# snmp-server group harig 3 priv read rview
FTOS#
Related
Commands
show snmp group – displays the group name, security model, view status, and storage type of
each group.
show running-config – displays the SNMP running configuration.
snmp-server host
Configure the recipient of an SNMP trap operation.
S5000
Syntax
snmp-server host ip-address | ipv6-address [traps | informs]
[version 1 | 2c | 3] [auth | no auth | priv] [community-string]
[udp-port port-number] [notification-type]
To remove the SNMP host, use the no snmp-server host ip-address [traps |
informs] [version 1 | 2c | 3] [auth | noauth | priv]
[
community-string] [udp-port number] [notification-type] command.
Parameters
ip-address Enter the keyword host followed by the IP address of the host
(configurable hosts is limited to 16).
ipv6-address Enter the keyword host followed by the IPv6 address of the host in the
x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zero.
traps (OPTIONAL) Enter the keyword traps to send trap notifications to
the specified host. The default is
traps.
informs (OPTIONAL) Enter the keyword informs to send inform notifications
to the specified host. The default is traps.
version 1 | 2c | 3 (OPTIONAL) Enter the keyword version to specify the security model
followed by the security model version number 1, 2c, or 3:
• Version 1 is the least secure version.
• Version 3 is the most secure of the security modes.
• Version 2c allows transmission of informs and counter 64,
which allows for integers twice the width of what is normally
allowed.
The default is version 1.
auth (OPTIONAL) Enter the keyword auth to specify authentication of a
packet without encryption.
1199