Command Line Reference Guide
snmp-server contact
Configure contact information for troubleshooting this SNMP node.
S5000
Syntax
snmp-server contact text
To delete the SNMP server contact information, use the no snmp-server contact
command.
Parameters
text
Enter an alphanumeric text string, up to 55 characters long.
Defaults none
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
snmp-server enable traps
Enable SNMP traps.
S5000
Syntax
snmp-server enable traps [notification-type] [notification-
option]
To disable traps, use the no snmp-server enable traps [notification-
type
] [notification-option] command.
Parameters
notification-type
Enter the type of notification from the list below:
• bgp—Notification of changes in the BGP process.
• ecfm—Notification of changes to ECFM.
• envmon—For Dell Networking, device notifications when an
environmental threshold is exceeded.
• isis—Notification of intermediate service traps.
• lacp—Notification of changes.
• snmp—Notification of RFC 1157 traps.
• stp—Notification of a state change in the spanning tree
protocol (RFC 1493).
• vlt—Notification of virtual link trunking.
• vrrp—Notification of a state change in a VRRP group.
• xstp—Notification of a state change in MSTP (802.1s),
RSTP (802.1w), and PVST+.
1195