Command Line Reference Guide

Usage
Information
Sample-rate is the average number of packets skipped before the sample is taken. This
command changes the global default sampling rate. You can configure an interface to use a
different sampling rate than the global sampling rate. If the value entered is not a correct
power of 2, the command generates an error message with the previous and next power of 2
value. Select one of these two packet numbers and re-enter the command.
Related
Commands
sflow sample-rate (Interface) – changes the Interface sampling rate.
sflow sample-rate (Interface)
Change the Interface default sampling rate.
S5000
Syntax
sflow sample-rate value
To return to the default sampling rate, use the no sflow sample-rate command.
Parameters
value
Enter the sampling rate value. The range is 256 to 8388608 packets.
Defaults The Global default sampling.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command changes the sampling rate for an Interface. By default, the sampling rate of an
interface is set to the same value as the current global default sampling rate. If the value
entered is not a correct power of 2, the command generates an error message with the
previous and next power-of-2 value. Select one of these two number and re-enter the
command.
Related
Commands
sflow sample-rate (Global) – changes the sampling rate globally.
show sflow
Display the current sFlow configuration.
S5000
Syntax
show sflow [interface type slot/port]
1186