Command Line Reference Guide

sflow extended-switch enable
Enable packing information on a switch only.
S5000
Syntax
sflow extended-switch enable
To disable packing information, use the no sflow extended-switch [enable]
command.
Parameters
enable Enter the keyword enable to enable global extended information.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
sflow extended-gateway enable – enables packing information on an extended gateway.
sflow extended-router enable – enables packing information on a router.
show sflow – displays the sFlow configuration.
sflow polling-interval (Global)
Set the sFlow polling interval at a global level.
S5000
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval command.
Parameters
interval value Enter the interval value in seconds. The range is 15 to 86400 seconds.
The default is 20 seconds.
Defaults 20 seconds
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The polling interval for an interface is the maximum number of seconds between successive
samples of counters to be sent to the collector. This command changes the global default
counter polling (20 seconds) interval. You can configure an interface to use a different polling
interval.
1184