Command Line Reference Guide

protocol-tunnel rate-limit
Enable traffic rate limiting per box.
S5000
Syntax
protocol-tunnel rate-limit rate
To reset the rate limit to the default, use the no protocol-tunnel rate-limit rate
command.
Parameters
rate Enter the rate in frames per second. The range is 75 to 3000. The
default is 75.
Defaults 75 frames per second.
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Example
FTOS#
FTOS#conf
FTOS(conf)#protocol-tunnel rate-limit 1000
FTOS(conf)#
Related
Commands
show protocol-tunnel – displays tunneling information for all VLANs.
show running-config – displays the current configuration.
show protocol-tunnel
Display protocol tunnel information for all or a specified VLAN-Stack VLAN.
S5000
Syntax
show protocol-tunnel [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN ID to
display information for the one VLAN. The range is 1 to 4094.
Defaults none
Command Modes EXEC
Command History
Version 9.0(1.3) Introduced on the S5000.
Example
FTOS#show protocol-tunnel
System Rate-Limit: 75 frames/second
VLAN Protocols Interface
1178