Command Line Reference Guide

For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
in | out | both Enter the keyword in, out, or both to debug incoming interfaces,
outgoing interfaces, or both incoming and outgoing interfaces.
vlan
vlan-id
Enter the keyword vlan followed by the VLAN id number from 1 to
4094.
count
value
Enter the keyword count followed by the number of debug outputs.
The range is 1 to 100.
Defaults Debug disabled.
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
protocol-tunnel
Enable protocol tunneling on a stacked (Q-in-Q) VLAN for specified protocol packets.
S5000
Syntax
protocol-tunnel {stp}
To disable protocol tunneling for a Layer 2 protocol, use the no protocol-tunnel
command.
Parameters
stp Enter the keyword stp to enable protocol tunneling on a spanning
tree, including STP, MSTP, RSTP, and PVST.
Defaults none
Command Modes CONF-IF-VLAN
Command History
Version 9.0(1.3) Introduced on the S5000.
Example
FTOS#conf
FTOS(conf)#interface vlan 2
FTOS(conf-if-vl-2)#vlan-stack compatible
FTOS(conf-if-vl-2)#member Te1/2-3
FTOS(conf-if-vl-2)#protocol-tunnel stp
FTOS(conf-if-vl-2)#protocol-tunnel enable
1176