Command Line Reference Guide

debug tacacs+
View TACACS+ transactions to assist with troubleshooting.
S5000
Syntax
debug tacacs+
To disable debugging of TACACS+, use the no debug tacacs+ command.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
ip tacacs source-interface
Specify an interface’s IP address as the source IP address for TACACS+ connections.
S5000
Syntax
ip tacacs source-interface interface
To delete a source interface, use the no ip tacacs source-interface command.
Parameters
interface
Enter the following keywords and slot/port or number information:
For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For Loopback interfaces, enter the keyword loopback
followed by a number from zero (0) to 16838.
For the Null interface, enter the keywords null 0.
For a Port Channel interface, enter the keywords port-
channel followed by a number. The range is 1 to 128.
For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
For VLAN interface, enter the keyword vlan followed by a
number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
1145