Command Line Reference Guide

max-age
Set the time interval for the RSTP bridge to maintain configuration information before refreshing that information.
S5000
Syntax
max-age seconds
To return to the default values, use the no max-age command.
Parameters
max-age
Enter a number of seconds the FTOS waits before refreshing
configuration information. The range is 6 to 40 seconds. The default is
20 seconds.
Defaults 20 seconds
Command Modes CONFIGURATION RSTP (conf-rstp)
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
forward-delay – changes the wait time before RSTP transitions to the Forwarding state.
hello-time – changes the time interval between BPDUs.
protocol spanning-tree rstp
Enter RSTP mode to configure RSTP.
S5000
Syntax
protocol spanning-tree rstp
To exit RSTP mode, use the exit command.
Defaults Not configured
Command Modes CONFIGURATION RSTP (conf-rstp)
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the system, use
the
no disable command from RSTP mode.
Example
FTOS(conf)#protocol spanning-tree rstp
FTOS(config-rstp)##no disable
Related
Commands
disable – disables RSTP globally on the system.
1113