Command Line Reference Guide

Defaults none
Command Modes SPANNING TREE (The prompt is “config-rstp”.)
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
protocol spanning-tree rstp – enters SPANNING TREE mode on the switch.
disable
Disable RSTP globally on the system.
S5000
Syntax
disable
To enable Rapid Spanning Tree Protocol, use the no disable command.
Defaults RSTP is disabled.
Command Modes CONFIGURATION RSTP (conf-rstp)
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
protocol spanning-tree rstp – enters SPANNING TREE mode on the switch.
forward-delay
Configure the amount of time the interface waits in the Listening State and the Learning State before transitioning to the
Forwarding State.
S5000
Syntax
forward-delay seconds
To return to the default setting, use the no forward-delay command.
Parameters
seconds Enter the number of seconds that FTOS waits before transitioning
RSTP to the forwarding state. The range is 4 to 30. The default is 15
seconds.
Defaults 15 seconds
Command Modes CONFIGURATION RSTP (conf-rstp)
1111