Command Line Reference Guide

47
Rapid Spanning Tree Protocol (RSTP)
The Dell Networking operating software (FTOS) implementation of rapid spanning tree protocol (RSTP) is based on the
IEEE 802.1w standard spanning-tree protocol. The RSTP algorithm configures connectivity throughout a bridged local
area network (LAN) that is comprised of LANs interconnected by bridges.
FTOS supports RSTP on the S5000.
bridge-priority
Set the bridge priority for RSTP.
S5000
Syntax
bridge-priority priority-value
To return to the default value, use the no bridge-priority command.
Parameters
priority-value
Enter a number as the bridge priority value in increments of 4096. The
range is 0 to 61440. The default is 32768.
Defaults 32768
Command Modes CONFIGURATION RSTP (conf-rstp)
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
protocol spanning-tree rstp – enters rapid spanning tree mode.
debug spanning-tree rstp
Enable debugging of RSTP and view information on the protocol.
S5000
Syntax
debug spanning-tree rstp [all | bpdu interface-type slot/port
{in | out} | events]
To disable debugging, use the no debug spanning-tree rstp command.
1109