Command Line Reference Guide
passive-interface
Suppress routing updates on a specified interface.
S5000
Syntax
passive-interface interface-type slot/port
To delete a passive interface, use the no passive-interface interface-type
slot/port command.
Parameters
interface-type
slot/port
Enter the interface type and slot/port or number information. Valid slot
numbers are 0-11. The valid port numbers for each interface type are
listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed by a
VLAN id number from 1 to 4094.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Although the passive interface does not send or receive routing updates, the network on that
interface is still included in RIP updates sent through other interfaces.
Related
Commands
neighbor – defines a neighbor.
network – enables RIP for a specified network.
redistribute
Redistribute information from other routing instances.
S5000
Syntax
redistribute {connected | static}
To disable redistribution, use the no redistribute {connected | static} command.
1090