Command Line Reference Guide

• For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE followed by slot/port numbers. The ports are 48,

52, 56, and 60.

• For a Port Channel interface, enter the keywords port-

channel

followed by a number from 1 to 128.

• For a VLAN interface, enter the keyword vlan followed by a

VLAN id number from 1 to 4094.

Defaults Not configured.

Command Modes ROUTER RIP

Command History

Version 9.0(1.3) Introduced on the S5000.

Usage

Information

When the offset metric is applied to an interface, that value takes precedence over an offset

value that is not extended to an interface.

Commands

ip prefix-list – enters PREFIX-LIST mode and configure a prefix list.

output-delay

Set the interpacket delay of successive packets to the same neighbor.

S5000

Syntax

output-delay delay

To return to the switch software defaults for interpacket delay, use the no output-delay

command.

Parameters

delay

Specify a number of milliseconds as the delay interval. The range is 8

to 50.