Command Line Reference Guide

network
Enable RIP for a specified network. Use this command to enable RIP on all networks connected to the switch.
S5000
Syntax
network ip-address
To disable RIP for a network, use the no network ip-address command.
Parameters
ip-address Specify an IP network address in dotted decimal format. You cannot
specify a subnet.
Defaults No RIP network is configured.
Command Modes ROUTER RIP
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You can enable an unlimited number of RIP networks.
RIP operates over interfaces configured with any address specified by the network
command.
offset-list
Specify a number to add to the incoming or outgoing route metrics learned using RIP.
S5000
Syntax
offset-list prefix-list-name {in | out} offset [interface-type
slot/port]
To delete an offset list, use the no offset-list prefix-list-name {in | out}
offset [interface-type slot/port] command.
Parameters
prefix-list-name Enter the name of an established Prefix list to determine which
incoming routes will be modified.
offset Enter a number from zero (0) to 16 to be applied to the incoming route
metric matching the access list specified. If you set an offset value to
zero (0), no action is taken.
interface-type
slot/port
(OPTIONAL) Enter the interface type and slot/port or number
information. Valid slot numbers are 0-11. The valid port numbers for
each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
1088