Command Line Reference Guide

maximum-paths
Set RIP to forward packets over multiple paths.
S5000
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths commands.
Parameters
number Enter the number of paths. The range is 1 to 16. The default is 4 paths.
Defaults 4
Command Modes ROUTER RIP
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
RIP supports a maximum of 16 ECMP paths.
neighbor
Define a neighbor router with which to exchange RIP information.
S5000
Syntax
neighbor ip-address
To delete a neighbor setting, use the no neighbor ip-address command.
Parameters
ip-address Enter the IP address, in dotted decimal format, of a router with which
to exchange information.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
When a neighbor router is identified, unicast data exchanges occur. Multiple neighbor routers
are possible.
Use the passive-interface command in conjunction with the neighbor command to
ensure that only specific interfaces are receiving and sending data.
Related
Commands
passive-interface – sets the interface to only listen to RIP broadcasts.
1087