Command Line Reference Guide

distribute-list out
Configure a filter for outgoing routing updates.
S5000
Syntax
distribute-list prefix-list-name out [interface-type slot/port
| bgp | connected | ospf | static]
To delete the filter, use the no distribute-list prefix-list-name out
command.
Parameters
prefix-list-name
out
Enter the name of a configured prefix list followed by the keyword
out.
interface-type
slot/port
(OPTIONAL) Enter the interface type and slot/port or number
information. Valid slot numbers are 0-11. The valid port numbers for
each interface type are listed below.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed by a
VLAN id number from 1 to 4094.
connected (OPTIONAL) Enter the keyword connected to filter only directly
connected routes.
ospf (OPTIONAL) Enter the keyword ospf to filter all OSPF routes.
static (OPTIONAL) Enter the keyword static to filter manually configured
routes.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
ip prefix-list – enters PREFIX-LIST mode and configures a prefix list.
1084