Command Line Reference Guide

debug ip rip
Examine RIP routing information for troubleshooting.
S5000
Syntax
debug ip rip [database | [events [interface-type slot/port] |
packet [interface-type slot/port]] | trigger]
To turn off debugging output, use the no debug ip rip command.
Parameters
interface-type
slot/port
(OPTIONAL) Enter the interface type and ID as one of the following:
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by slot/port numbers.
The port range is 0 to 63.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by slot/port numbers. The ports are 48,
52, 56, and 60.
• For a Port Channel interface, enter the keywords port-
channel followed by a number from 1 to 128.
• For a VLAN interface, enter the keyword vlan followed by a
VLAN id number from 1 to 4094.
NOTE: This option is available on the S5000 as a sub-option.
database (OPTIONAL) Enter the keyword database to display messages
when there is a change to the RIP database.
events (OPTIONAL) Enter the keyword events to debug only RIP protocol
changes.
trigger (OPTIONAL) Enter the keyword trigger to debug only RIP trigger
extensions.
Command Modes EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
default-information originate
Generate a default route for the RIP traffic.
S5000
Syntax
default-information originate [always] [metric metric-value]
[route-map map-name]
To return to the default values, use the no default-information originate
command.
1080