Command Line Reference Guide

Parameters
vlan-list Enter the list of secondary VLANs to associate with the selected
primary VLAN. The list can be in comma-delimited or hyphenated-
range format, following the convention for the range input.
Defaults none
Command Modes INTERFACE VLAN
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The list of secondary VLANs can be:
• Specified in comma-delimited or hyphenated-range format.
• Specified with this command even before they have been created.
• Amended by specifying the new secondary VLAN to be added to the list.
Related
Commands
private-vlan mode – sets the mode of the selected VLAN to community, isolated, or primary.
show interfaces private-vlan – displays the type and status of the PVLAN interfaces.
show vlan private-vlan – displays the PVLANs and/or interfaces that are part of a PVLAN.
show vlan private-vlan mapping – displays the primary-secondary VLAN mapping.
switchport mode private-vlan – sets PVLAN mode of the selected port.
show interfaces private-vlan
Display type and status of PVLAN interfaces.
S5000
Syntax
show interfaces private-vlan [interface interface]
Parameters
interface
interface
(OPTIONAL) Enter the keyword interface followed by the ID of the
specific interface for which to display PVLAN status.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command has two types of display — a list of all PVLAN interfaces or for a specific
interface. Examples of both types of output are shown below.
The following describes output from the show interfaces private-vlan command
shown in the Examples below.
1072