Command Line Reference Guide

Parameters
ip-dscp value (OPTIONAL) Enter the keywords ip-dscp followed by the IP DSCP
value. The range is 0 to 63.
mac-dot1p value Enter the keywords mac-dot1p followed by the dot1p value. On
theS5000, the allowed values are: 0, 2, 4, 6.
Defaults none
Command Modes CONFIGURATION (conf-qos-policy-in)
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
After the IP DSCP bit is set, other QoS services can then operate on the bit settings.
show qos class-map
View the current class map information.
S5000
Syntax
show qos class-map [class-name]
Parameters
class-name (Optional) Enter the name of a configured class map.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 9.0(1.3) Introduced on the S5000.
Example
FTOS#show qos class-map
Class-map match-any CM
Match ip access-group ACL
Related
Commands
class-map – identifies the class map.
1055