Command Line Reference Guide

layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class
Map. The default is Layer 3.
Defaults Layer 3
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The input policy map is used to classify incoming traffic to different flows using class-map, QoS
policy, or incoming packets DSCP. This command enables Policy-Map-Input Configuration
mode (conf-policy-map-in).
Related
Commands
service-queue – assigns a class map and QoS policy to different queues.
policy-aggregate – allows an aggregate method of configuring per-port QoS using policy maps.
service-policy input – applies an input policy map to the selected interface.
policy-map-output
Create an output policy map.
S5000
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name
command.
Parameters
policy-map-name Enter the name for the policy map in character format (16 characters
maximum).
Defaults none
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
The output policy map is used to assign traffic to different flows using QoS policy. This
command enables Policy-Map-Output Configuration mode (conf-policy-map-out).
Related
Commands
service-queue – assigns a class map and QoS policy to different queues.
policy-aggregate – allows an aggregate method of configuring per-port QoS using policy maps.
service-policy output – applies an output policy map to the selected interface.
1049