Command Line Reference Guide

policy-aggregate
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part of the policy
map (input/output) applied on an interface.
S5000
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the no policy-aggregate qos-
policy-name command.
Parameters
qos-policy-name Enter the name of the policy map in character format (32 characters
maximum).
Defaults none
Command Modes CONFIGURATION (policy-map-input and policy-map-output)
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Aggregate input/output QoS policy applies to all the port ingoing/outgoing traffic. Aggregate
input/output QoS policy can coexist with per queue input/output QoS policies.
1. If only aggregate input QoS policy exists, input traffic conditioning configurations (rate-
police) apply. Any marking configurations in aggregate input QoS policy are ignored.
2. If aggregate input QoS policy and per class input QoS policy coexist, aggregate input QoS
policy preempts per class input QoS policy on input traffic conditioning (rate-police). In
other words, if rate police configuration exists in the aggregate QoS policy, the rate
police configurations in per class QoS are ignored. Marking configurations in per class
input QoS policy still apply to each queue.
Related
Commands
policy-map-input – creates an input policy map.
policy-map-input
Create an input policy map.
S5000
Syntax
policy-map-input policy-map-name [layer2]
To remove an input policy map, use the no policy-map-input policy-map-name
[layer2] command.
Parameters
policy-map-name Enter the name of the policy map in character format (32 characters
maximum).
1048