Command Line Reference Guide

match ip dscp
Use a differentiated services code point (DSCP) value as a match criteria.
S5000
Syntax
match ip dscp dscp-list
To remove a DSCP value as a match criteria, use the no match ip dscp dscp-list
command.
Parameters
dscp-list Enter the IP DSCP value(s) that is to be the match criteria. Separate
values by commas — no spaces ( 1,2,3 ) or indicate a list of values
separated by a hyphen (1-3). The range is 0 to 63.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
You must enter the class-map command in order to access this command. After the class
map is identified, you can configure the match criteria.
The match ip dscp and match ip precedence commands are mutually exclusive.
Up to 64 IP DSCP values can be matched in one match statement. For example, to indicate IP
DCSP values 0 1 2 3 4 5 6 7, enter either the match ip dscp 0,1,2,3,4,5,6,7 or
match ip dscp 0-7 command.
NOTE: Only one of the IP DSCP values must be a successful match criterion, not all of the
specified IP DSCP values need to match.
Related
Commands
class-map – identifies the class map.
match ip precedence
Use IP precedence values as a match criteria.
S5000
Syntax
match ip precedence ip-precedence-list [set-ip-dscp value]
To remove IP precedence as a match criteria, use the no match ip precedence ip-
precedence-list [set-ip-dscp value] command.
Parameters
ip-precedence-
list
Enter the IP precedence value(s) as the match criteria. Separate
values by commas — no spaces ( 1,2,3 ) or indicate a list of values
separated by a hyphen (1-3). The range is 0 to 7.
1045