Command Line Reference Guide

are automatically configured; you cannot assign the service-class dynamic command
to individual interfaces in a port channel.
All traffic is by default mapped to the same queue, Queue 0. If you honor dot1p on ingress, you
can create service classes based the queueing strategy using the service-class
dynamic dot1p
command from INTERFACE mode. You may apply this queuing strategy to
all interfaces by entering this command from CONFIGURATION mode.
• All dot1p traffic is mapped to Queue 0 unless you enble the service-class
dynamic dot1p
command on an interface or globally.
• Layer 2 or Layer 3 service policies supercede dot1p service classes.
service-class bandwidth-weight
Specify a minimum bandwidth for queues.
S5000
Syntax
service-class bandwidth-weight queue0 number queue1 number
queue2 number queue3 number
Parameters
number Enter the bandwidth-weight. The value must be a power of 2. The
range is 1 to 1024.
Defaults none
Command Modes CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Guarantee a minimum bandwidth to different queues globally using the service-class
bandwidth-weight
command from CONFIGURATION mode. The command is applied in
the same way as the bandwidth-weight command in an output QoS policy. The
bandwidth-weight command in QOS-POLICY-OUT mode supercedes the service-
class bandwidth-weight
command.
strict-priority queue
Configure a unicast queue as a strict-priority (SP) queue.
S5000
Syntax
strict-priority queue unicast number
1040