Command Line Reference Guide

Usage
Information
To apply dot1p-queue-mapping, use the service-class dynamic dot1p command.
Related
Commands
show qos dot1p-queue-mapping – displays the dot1p priority to queue mapping on the switch.
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all interfaces (from
CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE mode entries.
S5000
Syntax
service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p
command.
Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-class dynamic
dot1p command. The default mapping is as follows:
Table 10. Default Mapping for 802.1p Traffic
dot1p Priority Value Queue ID
0 0
1 0
2 0
3 1
4 2
5 3
6 3
7 3
Command Modes
• INTERFACE
• CONFIGURATION
Command History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Enter this command to honor all incoming 802.1p markings on incoming switched traffic on the
interface. By default, this facility is not enabled (that is, the 802.1p markings on incoming traffic
are not honored).
You can apply this command on both physical interfaces and port channels. When you set the
service-class dynamic for a port channel, the physical interfaces assigned to the port channel
1039