Command Line Reference Guide

vlan hello-time
Set the time interval between generation of PVST+ 7 BPDUs.
S5000
Syntax
vlan vlan-range hello-time seconds
To return to the default value, use the no vlan hello-time command.
Parameters
vlan
vlan-range
Enter the keyword vlan followed by the VLAN number(s). The range
is 1 to 4094.
hello-time
seconds
Enter the keywords hello-time followed by the time interval, in
seconds, between transmission of BPDUs. The range is 1 to 10
seconds. The default is 2 seconds.
Defaults 2 seconds
Command Modes CONFIGURATION (conf-pvst)
Command History
Version 9.0(1.3) Introduced on the S5000.
Related
Commands
vlan bridge-priority – sets the bridge-priority value.
vlan forward-delay – changes the time interval before FTOS transitions to the forwarding state.
vlan max-age – changes the time interval before PVST+ refreshes.
show spanning-tree pvst – displays the PVST+ configuration.
vlan max-age
Set the time interval for the PVST+ bridge to maintain configuration information before refreshing that information.
S5000
Syntax
vlan vlan-range max-age seconds
To return to the default, use the no vlan max-age command.
Parameters
vlan
vlan-range
Enter the keyword vlan followed by the VLAN number(s). The range
is 1 to 4094.
max-age
seconds
Enter the keywords max-age followed by the time interval, in
seconds, that FTOS waits before refreshing configuration information.
The range is 6 to 40 seconds. The default is 20 seconds.
Defaults 20 seconds
1033