Users Guide

ManualsBrandsDell ManualsAccess PlatformsNetworking S3100 Series

791

792

793

794

795

796

797

798

799

800

To view the routing protocols configuration, use the show ip protocols command in EXEC mode.

Dell#show ip protocols

Routing Protocols is RIP

Sending updates every 30 seconds, next due in 23

Invalid after 180 seconds, hold down 180, flushed after 240

Output delay 8 milliseconds between packets

Automatic network summarization is in effect

Outgoing filter for all interfaces is

Incoming filter for all interfaces is

Default redistribution metric is 1

Default version control:

receive version 2, send version 2

Interface Recv Send

GigabitEthernet 1/1 2 2

Routing for Networks:

10.0.0.0

Routing Information Sources:

Gateway Distance Last Update

Distance: (default is 120)

Dell#

To configure an interface to receive or send both versions of RIP, include 1 and 2 in the command syntax. The

command syntax for sending both RIPv1 and RIPv2 and receiving only RIPv2 is shown in the following

example.

Dell(conf-if)#ip rip send version 1 2

Dell(conf-if)#ip rip receive version 2

The following example of the show ip protocols command confirms that both versions are sent out that

interface. This interface no longer sends and receives the same RIP versions as Dell Networking OS does

globally (shown in bold).